Rupert Neve Shelford Channel 通道条

iPhone

Rupert Neve Designs 5088 Shelford Console - 48 Channel


Rupert Neve Shelford Channel, over a half century in the making, is the definitive evolution of Mr. Neve&＃39;s renowned 80 Series channel module technology, updated and refined for the contemporary studio. The Shelford Channel is fitted with Rupert&＃39;s latest Class A transformer-gain mic preamp, the best-of-the-classics Inductor EQ from the Shelford 5052, a punchy diode-bridge compressor, the alluring analog textures of variable Silk saturation, a state-of-the-art dual-tap transformer output stage with massive headroom, and double the operating voltage of vintage designs. Offering rich tonal options for making audacious statements with your music, along with precision-detented controls for recall, the Shelford Channel delivers the authoritative sonic essence of classic Rupert Neve designs, along with modern versatility.

Mic-DI/Line: switches between microphone/direct injection input and line input

GND Lift: disconnects the audio signal ground from chassis earth

Signal LED: green indicates Signal Present; red indicates imminent input stage clipping

Mic Gain: 12-way precision rotary, controls gain from 0dB to 66dB in 6dB steps

Trim: rotary switch provides further continuous gain adjustment of +/-6dB

48V: switch engages phantom power on the mic input

Phase: inverts the polarity of the signal path (illuminates when engaged)

HPF Freq: engages a 12dB/octave highpass filter, variable from 20Hz-250Hz

The best-of-the-classics inductor EQ

EQ In: engages all EQ frequency bands except HPF

LF: adjusts up to 15dB of boost/cut at the selected low frequency

Low Freq: 4-position rotary switch for selecting LF band corner or center frequency

LF Peak: selects LF shelving (out) or peaking (in) mode

Mid Hi Q: selects between a mid-band resonance of 2 (out) or 3.5 (in)

Mid: adjusts up to 15dB of boost/cut at selected mid frequency

Mid Freq: 6-position rotary switch selects center frequency of the midband EQ stage

HF Peak: selects HF shelving (out) or peaking (in) mode

8K/16K: selects between an 8kHz (out) or 16kHz (in) center or corner frequency for HF band

HF: adjusts up to 15dB of boost or cut at selected high frequency

The Super Diode-bridge Compressor

Side Chain Insert Jacks (rear-panel): for fine tuning of compressor operation

Comp In: engages the Channel&＃39;s compressor-limiter section

Threshold: sets level where the compressor "kicks in"

Ratio: sets compression slope from 1.5:1 (minimal) to 8:1 (heavy)

SC Insert: inserts rear-panel sidechain insert jacks into sidechain signal path

HPF to S/C: routes highpass filter into the circuit that compressor uses to determine level

Gain: for adding make-up gain to compensate for level attenuation lost to compression

Timing: 6-position rotary adjusts attack/release speed of the compressor

Link: links the sidechain control of multiple units for ganged or stereo operation

Pre EQ: changes the order of compressor in the circuit chain

Blend: mixes the dry and compressed signal for handy parallel compression

Fast: speeds up both attack and release of the selected compressor time constant

zgypw

支持。:handshake